Data Structures

Here are the data structures with brief descriptions:

[detail level 12]

CADC_REGISTERS_T	Struct we use so we can address registers using field names
CAUX_COMPARATOR_REGISTERS_T
CCHAN_SETTINGS_T
CDEEP_POWER_DOWN_REGISTERS_T	Offsets for where to find chip registers needed for Deep Power Down register which is used to see section 4.8 and 5.5 in the chip datasheet
CFAST_TIMER_REGISTERS_T
CGPIO_REGISTERS_T
CI2C_REGISTERS_T
CPOWER_MGMT_REGISTERS_T	Offsets for where to find chip registers needed for Power Mgmt register. This is not documented in the Reference Manual
CPWM_REGISTERS_T	Struct we use so we can address registers using field names
CRCO32K_REGISTERS_T
Crco32k_result0_
Crco32k_result1_
CRTC_REGISTERS_T	Struct we use so we can address registers using field names
CSECURITY_CTRL_REGISTERS_T
CSLOW_TIMER_REGISTERS_T
CSPI_REGISTERS_T	Struct we use so we can address registers using field names
CSYS_CTRL_REGISTERS_T	Offsets for where to find chip registers needed for System Control register which is used to configure GPIO pins (what mode are they in and pull up/down and open drain enable, etc see section 19.3 in the chip datasheet
CTIMER_REGISTERS_T
Ctr_aux_comp_ana_ctl_s
Ctr_aux_comp_ana_ctl_b
Ctr_cli	Structure which defines the current state of the CLI
Ctr_cli_buffer_stats_t	Structure containing CLI buffer driver statistics
Ctr_command_s	Structure used for each CLI command table entry
Ctr_hal_adc_settings_t
Ctr_hal_gpio_pin_t	Pin type
Ctr_hal_gpio_settings_t
Ctr_hal_i2c_int_count_t
Ctr_hal_i2c_settings_t
Ctr_hal_pwm_settings_t
Ctr_hal_rtc_date	Convenience structs for use when passing around dates, times, or both
Ctr_hal_rtc_date_time
Ctr_hal_rtc_settings_t
Ctr_hal_rtc_time
Ctr_hal_spi_settings_t
Ctr_hal_timer_settings_t
Ctr_hal_uart_settings_t
Ctr_hal_wdog_settings_t
Ctr_mfg_tok_type_cbke_283k1_data
Ctr_mfg_tok_type_cbke_data
Ctr_mfg_tok_type_cca_threshold
Ctr_mfg_tok_type_installation_code
Ctr_mfg_tok_type_manuf_id
Ctr_mfg_tok_type_phy_config
Ctr_mfg_tok_type_security_config
Ctr_mfg_tok_type_thread_join_key
Ctr_mfg_tok_type_version
Ctr_mfg_tok_type_xtal_trim
Ctr_ring_buffer_t	Ring buffer object definition
Ctr_sadc_ana_set0_s
Ctr_sadc_ana_set0_b
Ctr_sadc_ana_set1_s
Ctr_sadc_ana_set1_b
CTRNG_REGISTERS_T
CUART_REGISTERS_T
CWDOG_REGISTERS_T	Struct we use so we can address registers using field names
CXDMA_REGISTERS_T	Offsets for where to find chip registers needed for xDMA register . see section 10.3in the chip datasheet